The line cycling: lids opening ahead of the basket, a powered lift at every station, and the basket held above the bath so drag-out runs back in.
What you are looking at
A three-tank line running on site: degrease, rinse, then hot-air dry. Watch the lids. They open ahead of the basket rather than when it arrives, so the transfer never waits on a lid. Every station has its own powered lift, and after each stage the basket is held above the bath so the drag-out runs back into the tank it came from.
That last detail is worth more than it looks. Liquid carried out of a tank on the part is liquid you have to buy again, and liquid that lands in the next tank is contamination you then have to manage. Holding the basket to drain is the cheapest process control on the line.
What a line does that a single tank cannot
- Separates the jobs. Degrease, rinse and dry each want a different chemistry and a different temperature; one tank forces a compromise.
- Repeats the cycle. The programme holds times and temperatures, so the result does not depend on who is on shift.
- Keeps the rinse clean. A dedicated rinse stops detergent drying on the part and leaving a film the customer sees.
- Comes out dry. Parts that go straight to assembly or paint cannot be left to air-dry on a bench.
Is a line right for you?
A line earns its keep on volume and on consistency. If you are cleaning the same family of parts all day, or you have to certify the result, the automation pays. If the work is varied and occasional, a single tank and a good cycle card will usually do more for less. Tell us what goes through in a week and we will say which one we would put in.
Every clip here is a documented job
Where an application needs proving, we clean, film, gauge and document it, and the process card stays with the customer.