The tank under test on the floor, transducers running. Factory test before despatch.
What you are looking at
This is a factory test. The tank is on our own workshop floor, filled, heated and running, with the camera moving along its length while the transducers work. Every machine we build is run like this before it is crated, because the only honest proof that a tank cavitates evenly is to fill it and listen to it.
What you cannot see on a video is the part that matters most: the field has to be the same at both ends of a long tank and the same at the bottom as near the surface. A tank that is strong in the middle and weak in the corners will clean the middle of a load and leave the rest. On a tank this length that is the whole engineering problem.
Why a long immersion tank is built this way
Long parts are the reason the UltraMax HX exists. Tube bundles, heat exchanger cores, coolers, shafts and frames do not fit a standard tank and cannot be cleaned in halves without a witness line where the two dips met. The answer is one bath long enough to take the whole part, with transducer banks spread so the field does not fall away down the length.
Heating, filtration and the lift are built to the same length. A part this size displaces a great deal of liquid, so the bath has to recover temperature quickly after the load goes in, and the filtration has to carry the soil away rather than let it settle back onto the part as it is lifted out.
Before you commit to anything
Send us your worst part. We run it, photograph it before and after, and give you the cycle card that produced the result: chemistry, concentration, temperature, frequency and time. The machine is then specified from that result rather than from a brochure.
Every clip here is a documented job
Where an application needs proving, we clean, film, gauge and document it, and the process card stays with the customer.