Home / Videos / SonoLift gear clean
Sono series · SonoLift

Sono series: SonoLift: a gear set cleaned on the lift

The load lowered, oscillated through the field, and lifted clean. Nothing in the tank touches the part except the liquid.

What you are looking at

A gear set carrying carbon and oil, cleaned on a SonoLift. The load is lowered, oscillated through the field, and lifted out clean. Nothing in the tank touches the part except the liquid, no brush, no blast media, no rodding.

The oscillation is deliberate. A part held still sits in a fixed pattern of strong and weak points in the ultrasonic field, so some teeth get worked harder than others. Moving the load through the field evens that out, which on a gear set is the difference between clean flanks and a clean side.

Why this matters on gears and splines

Gear teeth, root fillets and splines are exactly the geometry that defeats a spray washer. The jet reaches the crown and the open faces; it does not reach into the root or along the flank at the angle needed. Ultrasonic cleaning works wherever the liquid flows, so the root and the flank are cleaned at the same time as the crown.

It also matters that nothing abrasive is involved. Blasting a gear set alters the surface and can leave media in the roots, which then goes into the box with the oil. Ultrasonic cleaning takes the soil off and leaves the surface as it found it.

Running it as a process

  • Load so parts are fully under the liquid and not stacked on one another.
  • Turn parts so blind holes and cavities can vent, air pockets do not clean.
  • Hold the chemistry and the temperature; both matter more than time does.
  • Rinse and protect afterwards if the parts are not going straight into assembly.

Prove it on your own set

Send us the dirtiest set you have. The trial comes back with photographs and the cycle card that produced the result.

Every clip here is a documented job

Where an application needs proving, we clean, film, gauge and document it, and the process card stays with the customer.

Talk to an engineerRead the case studies