Home / Videos / UltraMax HX 12 in build
UltraMax HX · in build

UltraMax HX 12: the tube bundle tank in build

The 12 m tank on the workshop floor during build: the full length of the shell, clad and railed, before fit-out.

What you are looking at

This is the shell on the workshop floor partway through build: clad, railed, and not yet fitted out. The transducer banks, heating, filtration, controls and lift all go in after this stage. We film the builds because a tank of this length is hard to picture from a drawing, and customers want to see the thing they are buying take shape.

The full run of the shell is what matters here. A tank for tube bundles has to take the whole bundle in one dip. Cleaning a long part in two halves leaves a mark where the two baths met, and on a heat exchanger core that mark is exactly where a customer looks first.

What goes in after this

  • Transducer banks spread along the length so the field does not fall away at the far end.
  • Heating sized for the load, so the bath recovers temperature after a cold part goes in.
  • Filtration that carries soil out of the bath instead of letting it settle back on the part.
  • A lift rated for the part, not just for the basket.
  • Controls that hold the cycle: temperature, time, sweep and degas, the same every run.

Built here, to the part

Machines at this size are not taken off a shelf. The tank is built around the biggest part you need to clean, the way you need to load it, and the floor you have to put it on. If you have a part that will not fit anything you have been shown, send us the drawing and the soil, and we will tell you plainly whether ultrasonics is the right answer for it.

Every clip here is a documented job

Where an application needs proving, we clean, film, gauge and document it, and the process card stays with the customer.

Talk to an engineerRead the case studies